ROCKER-DOCTOR TM
Universal Tie Down & Pull Clamp
Part No. TH14.000
| The Rocker-Doctor is a new low cost uni-body tie down and pull clamp that will pull sheet metal panels better than any other method, where no access to the back is available and straight line pulling is required. It is intended that the Rocker-Doctor be sold and used in pairs, because in some cases, it is better to spread the load or even out the pulling force. It is a 2 ton clamp and, in some cases, not effective by itself. |
   |
The Rocker-Doctor is a simple to use clamp. It can be installed in less than a minute. Using the back bar as a template, you drill two holes, then insert a Chrome Moly backing bar. Lock on backing bar with a ball shaped nut and you're ready to pull or tie down. The Rocker-Doctor gives more straight line pulling area than The Two-Holer. It is a method approved for pulling the new hi-carbon steel box members on uni-body cars. It will hang on the car body by itself, making hook-ups fast and easy. The clamp is made of U.S. Chrome Moly Tool Steel and has a four ton capacity. It will effectively straighten door frames, quarter panels, hoods, fenders, rocker panels, rear decks and sub frames. These tools, in one use, will more than pay for themselves. In some cases, it is the only way to straighten, other than cutting the panel off the car. It eliminates the welding of pull tabs on the sheet metal panels, that will tear off and create more damage than was originally there. On new hi-carbon panels, welding will just tear holes across the weld area, leaving a gap worse than the original damage. The Rocker-Doctor is not intended to replace The Two-Holer, because it is not as universal a tool. But, it has so many additional uses, it makes an excellent companion tool for The Two-Holer. The Two Holer and the Rocker-Doctor simplify uni-body panel straightening. These tools offer a totally different approach to blind pulling panels like rockers, cowls, pillars, fenders, or any portions of the uni-body, where no access from behind exists. By far, the lowest cost dent repair system on the market today. Considering the productivity and low initial cost, no shop in the 2000's should be without them. |
Next Product (The Skinner) |
 |
|
| Call For Prices |
| WIVCO Design 47888 Highway 18 West Canton, South Dakota 57013 |
WEB: www.wivco.com E-MAIL:  TOLL FREE NO. 1-866-799-7997 PHONE NO. 605-764-9200 FAX NO. 605-764-9201 |
 |