THE TWO HOLER TM
Revolutionary New Body and Fender Dent Puller
Part No. TH12.000
The Two Holer gets its name from the fact that the user makes two holes in the uni-body sheet metal from the front. Insert the Z shaped bar into one hole. Insert the pulling hook, which grasps the bar at the center of its length, into the second hole. The pull is then made by hydraulic power in which the user has total command over the sheet metal panel. Although this sounds like a simple tool, a look at the kit shows the care and planning that has gone into it. The hooks and Z bars come in three diameters: high tensile alloy tool steel sized for 2,000, 6,000, and 13,000 pounds of pulling force. To prevent breakage by excessive mechanical force, the tool kit includes a slip coupling with a shear pin in it. This is used with the two smaller hooks and the shear pin will break before the strength of the hook is exceeded. Spare shear pins are included in the kit. |
In short, The Two Holer is a simple but high quality tool that represents a revolutionary new approach to dent pulling. The return on investment should come quickly. The Two Holer and the Rocker-Doctor simplify uni-body panel straightening. These tools offer a totally different approach to blind pulling panels like rockers, cowls, pillars, fenders, or any portions of the uni-body, where no access from behind exists. By far, the lowest cost dent repair system on the market today. Considering the productivity and low initial cost, no shop in the 2000's should be without them. |
Next Product (Rocker-Doctor) |
 |
|
| Call For Prices |
| WIVCO Design 47888 Highway 18 West Canton, South Dakota 57013 |
WEB: www.wivco.com E-MAIL:  TOLL FREE NO. 1-866-799-7997 PHONE NO. 605-764-9200 FAX NO. 605-764-9201 |
 |